Do you have any vacuum gauges at all to test the pump? ( Though I doubt that is the problem based upon your tests )
Investing in a freeze dryer is not just about saving money; it's about gaining the skills and resources to become more self-reliant and prepared for whatever life throws your way. So, invest in your self-reliance journey – your future self will thank you!
You can freeze dry things with fat and oils in it. The point isn’t to completely get rid of all the fat, but to reduce it. The reason being is for the storage process.
5. Maintenance: Understand the maintenance requirements of the machine. Some units require more frequent servicing than others.
Most foods can be freeze dried; however, items with high fat content like avocados may not preserve as well as low-fat foods like fruits or vegetables.
I did a couple of batches (peas and carrots, and another load of precooked chicken meatballs cut in half) and it all worked perfectly. Looking forward to trying out some new things and sharing the results.
Other companies sell “beef crumbles” or other versions of scrap beef that have nearly as much fat as protein, and they often sell for more than we do.
3) Inside the front panel I installed a plastic shield over the display card and a water deflector just below the hole to route the exterior condensation to an 11x17 pan beneath the FDer.
Drying things out played a roll as well as the added insulation. We had 3.5 weeks of constant rain here in central NC with humidity over 95% and temps near 95F in the beginning and tapering down to 80F by the end of the rain. The condensation on the front panel around the seal had water running down the front of the Freeze Dryer constantly during the entire cycle, not just the freeze cycle. I initially went into the FDer to simply stop the humdity from reaching the outer chamber shell and freezing.
With their get more info assist, it is possible to maintain uniform thickness and Room amongst food slices, advertising and marketing even drying and optimum texture.
Posted January 21, 2016 (edited) On 12/1/2015 at 0:16 PM, Jenipher said: Tony, if you see this, I went ahead and purchased the catch can. Do you think it's okay to just purchase a reducer to go from the size of the exhaust to the size of the hose that came with the can? Hopefully I said that in a way that makes sense! As well, does it matter which port is used as "in" and which as "out"? Thanks so much, Jen Hi Jen, Sorry to be gone so long. I did exactly as you proposed. I purchased a brass reducer and pushed the blue hose over it.
Run full system test with no food in chamber (results, 630 mTorr lowest steady reading - looking through the oil level window, some bubbling seen in oil even after an hour of pumpdown - some "air" noises from pump)
Affiliate marketers: We’re reader-supported. When you purchase as a result of hyperlinks on our web page, we may perhaps get paid an affiliate commission
I hope companies will have more “Albert” in their team for the satisfaction of their customers! Thank you so much Trimleaf for helping us purchase this great product! Team Albert here!